3M™ Adhesion Promoter Wipes

Gap Supply

AP-3M4298

Provide the strongest adhesion for your LED strip light to most surfaces and bare metals. A safe and proven method, this adhesion solution is ideal for all of your Gap Supply LED lighting purchases.
3M Adhesion Promoter is a liquid primer used for most low surface energy plastics, finished wood, and melamines or interior trim applications. It is specifically formulated to be used with 3M Tapes. Since formulations and surface energies can vary for these types of materials, each application should be verified through testing. This adhesion promoter is supplied in an easy-to-use sponge applicator packet. Gap Supply highly recommends utilizing this adhesion for your LED light mounts. Being easy to use, showing little to no risk for your LED lighting fixtures, and providing a no-mess clean-up, these 3M adhesion solutions take the options here at Gap Supply to the next level.

3M Application Procedure: the liquid contents of the packet should be used in their entirety as soon as possible after opening. Hold packet upright and avoid squeezing in order to prevent spillage of liquid contents. The packet can be opened by tearing across the top of the packet at the notches, which will expose the sponge applicator. Do not remove the sponge or squeeze a freshly opened packet. Handling the bottom section of the packet should allow users to administer the 3M adhesion promoter with no mess. Apply a thin, uniform coating to the bonding surface, using the minimum amount that will fully coat the surface. A wet coating thickness of 0.002 inch or less is recommended, we promise that’s all you’ll need. Apply promoter only to areas that will be fully covered with tape. Although drying times may vary due to temperature and/or humidity, a drying time of 30 to 90 seconds is typically indicative of this thickness. The primer should be dry before applying tape. For best results, apply tape immediately after primer application or no more than one hour afterwards. Be sure the primed surface remains free from contaminants prior to tape application.
This adhesive can be utilized for those tricky situations when it comes to hiding wiring for your LED’s under cabinet lighting, tape lighting, or other LED light fixtures. Whether used alone or in conjunction with LED light mounts, you can rest assured knowing your indoor LED lighting will stay secure. Be sure to get yours from Gap Supply today!

SOLD IN INDIVIDUAL PACKS

3M Scotch 4298 Adhesion Promoter (Sponge Applicator Packet) Specifications

  • Drying Time: 30 to 90 seconds
  • Flashpoint:: -20°C (-4°F)
  • Coverage: Approximately 150 square inch per packet
* specifications are those given by manufacturers and are not tested for accuracy


Related Items